Build your own two inch kitty lift.
Posted: January 1st, 2010, 4:48 pm
What I have for sale is rear plates that will raise the rear of your kitty two inches. These plates will leave you with only having to raise the front end. This can be done with spindle modification or installation of a spacer block between the spring and spring saddle. This is a great father and son (or daughter) project that will improve the sleds performance in deeper snow, in other words it wont get stuck as much.
These plates are constructed of 11 ga. Mild steel that are laser cut. I developed these plates for some relatives / co-workers. They are based on the lift I made a couple years ago and have refined with some minor adjustments based on track length calculations / wheel placement. If you are not happy with these plates I will take them back less shipping cost. The only reason I have these is because the shop that made them had a minimum for the run. I have about 6 extra sets.
The price is $40 shipped (to lower 48) for 2 unpainted plates shown below. No hardware included. I will Include a CADD drawing of lift blocks that can be made that will provide the 2” of required lift and spread the skis 3 1/2” for added stability. PM me if interested or if you have any questions. Or e-mail jkav72@msn.com (PM's have been slow)
These plates are constructed of 11 ga. Mild steel that are laser cut. I developed these plates for some relatives / co-workers. They are based on the lift I made a couple years ago and have refined with some minor adjustments based on track length calculations / wheel placement. If you are not happy with these plates I will take them back less shipping cost. The only reason I have these is because the shop that made them had a minimum for the run. I have about 6 extra sets.
The price is $40 shipped (to lower 48) for 2 unpainted plates shown below. No hardware included. I will Include a CADD drawing of lift blocks that can be made that will provide the 2” of required lift and spread the skis 3 1/2” for added stability. PM me if interested or if you have any questions. Or e-mail jkav72@msn.com (PM's have been slow)