Hey Guys! Anyone having trouble logging in drop me an email, still a few bugs with logging in!

CDI Installation

Kawasaki or Suzuki, assembly, disassembly, troubleshooting questions.

Moderators: Old School, harryparatestis

Post Reply
scotty1441
Posts: 8
Joined: Sun Feb 24, 2013 10:31 pm

CDI Installation

Post by scotty1441 » Fri Dec 18, 2015 9:12 pm

I picked up a CDI conversion unit last year and I'm a little confused on the installation instructions. As can be seen from the attached pic there 4 wires coming from the condensor. The blue wire to the points, the braided black wire to the main coil and two other black wires that run in underneath the plate. The instructions don't mention what to do with the other two black wires that run from under the palte. My assumption is that they are to be joined together with the black wire from the main coil and all 3 of those wires go to the positive output on the CDI box?

Any input?

I just want to make sure before I start cutting wires.

Image


Jonn
Posts: 129
Joined: Sun Feb 06, 2005 5:36 am
Location: North of MPLS/St. Paul

CDI Install Instructions

Post by Jonn » Mon Dec 21, 2015 2:13 am

Below is a link to the most recent instruction documents for both Suzuki and Kawasaki. Essentially you'll have to solder all the remaining wires that were connected at the top of the coil together as defined in step 5 for Suzuki.

http://obups/products/images/El ... i_2015.pdf

I hope this helps you out.

Jonn
Jonn
Olson Brothers
http://obups
651-395-2296

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests