We will be refreshing and updating the forum over the next few weeks. You can still register and talk sleds... |
windsheild / visor low cut question
Moderators: Old School, harryparatestis
-
- Posts: 48
- Joined: November 5th, 2010, 2:01 pm
- Location: Blakeslee PA
windsheild / visor low cut question
seen from some of the picture on here a low cut windsheild / visor.
anyone know where I can get one?
Thanks Mike
anyone know where I can get one?
Thanks Mike
Mike Barry
-
- Posts: 42
- Joined: November 4th, 2011, 11:52 am
- Location: So. Maine
Re: windsheild / visor low cut question
I made mine (the green sled with the 2.5 four stroke. Took a pice of cardboard and made a template. Had a piece of lexan and just bent it in a brake.SlackerP488 wrote:seen from some of the picture on here a low cut windsheild / visor.
anyone know where I can get one?
Thanks Mike
-
- Posts: 79
- Joined: September 21st, 2005, 4:08 pm
- Location: Mb. Canada
If you dont have a break and are carefull, you can heat up lexan or acrylic with a torch and bend it. Light and quickly sweep the flame along where you want to bend, when soft bend a little bit farther than you want it and hold it till it cools. When it cools it will hold it's shape. It may end up stronger than just bending.
-
- Posts: 48
- Joined: November 5th, 2010, 2:01 pm
- Location: Blakeslee PA
Lexan
Hey thanks guys I will give that a try. I know Lowes has lexan Ill check it out.
929rog love the 4 cycle and the video. that might be a summer project for my kitty. the ole 72 2 stoke runs great, but so darn stinky...
929rog love the 4 cycle and the video. that might be a summer project for my kitty. the ole 72 2 stoke runs great, but so darn stinky...
Mike Barry
Who is online
Users browsing this forum: No registered users and 10 guests