Page 1 of 1
Kitty Cat Studs for 1973
Posted: November 10th, 2010, 10:28 am
by trdehmer
I have the stock track on my 1973 Kitty Cat with no paddles. What studs can I run on these things and who sells them?
How many do most run?
Not for racing, just for extra traction and stopping capability on slick surfaces like ice...
Thanks!
Posted: November 14th, 2010, 2:42 pm
by brad6
I just used 1/4" By 1-1/4" stainless bolts with stainless fender washer on each side and Stainless lock nuts. Had to cut a bit off each bolt and then ground the ends a bit to round over. Can't remember how many I put on, But i went with a staggered pattern in the center section of the track. Just need snow now to try it out!! There is a pic if u search this topic from somelse who had did this as well
I just used your advise I put 12 in works GREAT!!!!!!!!!!!
Posted: January 30th, 2011, 2:57 pm
by sterlingc12
brad6 wrote:I just used 1/4" By 1-1/4" stainless bolts with stainless fender washer on each side and Stainless lock nuts. Had to cut a bit off each bolt and then ground the ends a bit to round over. Can't remember how many I put on, But i went with a staggered pattern in the center section of the track. Just need snow now to try it out!! There is a pic if u search this topic from somelse who had did this as well
traction
Posted: February 1st, 2011, 8:58 pm
by brad dodge
dennis kirk sells a kit for kitty cat
Re: traction
Posted: February 5th, 2011, 11:28 pm
by Rick
brad dodge wrote:dennis kirk sells a kit for kitty cat
Called 2/4 and they do not.