Just picked up a 77 from a buddy of mine. It had been sitting for quite some time and he didn't know what was wrong with it. Was hoping to get away with a carb clean, fresh gas, and a plug. Not the case. No spark, coil is good though!
I was wondering if anybody had any ideas on pulling the rotor off to get to the magneto assembly. I was thinking about using a harmonic balancer but need to find longer bolts if I'm going to attempt it. Little wary because the bolts are so small.
Any suggestions would be appreciated
Also there is a screw on the rotor. Looks like there might be a magnet inside? Don't know haven't got it off yet. What's the proper way to getting the correct gap between them?
Thanks
We will be refreshing and updating the forum over the next few weeks. You can still register and talk sleds... |
77 magneto
Moderators: Old School, harryparatestis
Who is online
Users browsing this forum: No registered users and 7 guests