Bogey replacement

UncleBuck · Post by **UncleBuck** » December 28th, 2004, 12:50 pm

Could some one tell me if the bogey's for a 72 Kitty cat are "pressed" on? Thank you.

harryparatestis · Post by **harryparatestis** » December 28th, 2004, 9:57 pm

Not to my knowledge, they are probably just a little stuck.. try some WD-40 and I used the spacers and a 2x4 and knocked them off, once you clean up the shaft, they should slide right back on. I could be wrong, but on my 72 they were just floating on the shaft seperated by spacers and washers. Good luck.. KO

Curtis · Post by **Curtis** » December 29th, 2004, 12:14 am

No they are not pressed on. They get rusty. You can knock them loose, but it takes a little time.

uncleBuck · Post by **uncleBuck** » January 26th, 2005, 4:26 pm

Thank - you ! that did the trick.

harryparatestis wrote:Not to my knowledge, they are probably just a little stuck.. try some WD-40 and I used the spacers and a 2x4 and knocked them off, once you clean up the shaft, they should slide right back on. I could be wrong, but on my 72 they were just floating on the shaft seperated by spacers and washers. Good luck.. KO

Kitty Cat Snowmobiles

Bogey replacement

Bogey replacement

Bogey

Who is online