72 or 73 no spark

[trmartin4472]

In need of testing process and specks for a 1972 Kawasaki motor had spark when parked points have been cleaned

[ziggster]

Here is a cookie cutter explanation on how to check for no spark, maybe this can help...

Testing for spark on an engine with points involves a few steps. Here's how to do it:

• Make sure the spark plug is clean and properly gapped. If it's dirty or the gap is too wide or too narrow, clean or adjust it as needed.
• Locate the ignition coil and distributor cap. The ignition coil is usually a cylinder-shaped object with several wires coming out of it, and the distributor cap is a round plastic or metal cover that sits on top of the distributor.
• Remove the distributor cap and rotor. The rotor is usually held in place by a screw or clip.
• Turn the ignition key to the "on" position. This will power the ignition coil and create a spark at the points.
• Use a spark tester or a spare spark plug to check for spark. Connect the tester or spare plug to the ignition wire and ground the other end of the tester or plug to the engine block.
• Crank the engine over using the starter or pull cord. Watch for a spark in the tester or spark plug. If you see a spark, the ignition system is working properly. If you don't see a spark, there may be a problem with the ignition coil, points, or wiring.
• Check the points for wear or damage. If the points are worn or damaged, they may need to be replaced.
• If you have checked everything else and still do not have spark, there may be a problem with the ignition coil, condenser, or other components in the ignition system.

Oh yeah, and be sure to wear safety glasses and keep loose clothing, jewelry, and long hair away from the engine while performing this test. Safely working on your Kitty Cat should always be your priority.